3.5 OD Spring Perch
Pick-up in store to earn an extra discount
Financing available with Flexiti
Request an install quote at check-out
See our work in our Install Gallery
Free shipping on orders over $99 (some exclusions)
3.5 OD Spring Perches
When installing lifted rear leaf springs, it's best to rotate the pinion so it points directly at the rear transfer case output flange and use a CV style drive shaft. The best way to rotate the pinion is to cut off the old perches and weld in a new set at the proper angle. These Spring Perches are made for 3.5 OD axle tubes including Trail-Gear's Fabricated 8", 8" E-locker, and 8.4" axle housings. Normally the spring pin is installed in the center hole but you can also move the rear axle forward or backward 1" by using the optional holes. Made from 1/4 plate steel. Unpainted finish.
Sold in Pairs.
